Why choose CAT Commenication Adapter III ?

 Why choose CAT Commenication Adapter III ?

 

1.With this service tool users can:
View active and logged diagnostics.
View events where irregularities occurred and were logged by the ECM.
View the status of a group of parameters (temperatures, pressures, etc.) simultaneously.
Record and log performance data.
Graph a group of status parameters.
View the current configuration of an ECM.
Change ECM configurations.
View the current configuration of an ECM.
Change ECM configurations.
Perform diagnostic tests.
Perform calibrations.
Print reports and diagnostic results.

2.With this kit you can:
communicate with the ECMs through a communication data link, allowing existing and potential problems to be diagnosed, products to be configured, and data to be obtained for analysis.


 

Please feel free to contact us ,

If you have any question:Email: Sales@obd2.ltd

 

评论

发表评论

此博客中的热门博文

CAT Caterpillar ET Diagnostic Adapter 3 problem solve

图片
  Recently so many people meet this problem ,after they use the cat caterpillar ET Diagnostic Adapter 3 to connect with the vehicle, the light could not turn on and could not work. How to solve this problem? CAT Caterpillar ET Diagnostic Tool (9 pin Adapter) connect with the cat vehicle ,CAT Caterpillar ET main device the light is not turn on ,and the device could not work ,as following picture. Change the all new CAT Caterpillar ET Diagnostic Tool ,the result is same . After we checked the CAT vehicle ‘s diagnostic seat, then find the question . the reason is that there is some cat vehicle’s diagnostic seat is not standard, and that is not matched with our 9 pin diagnostic connector . some people cat vehicle the diagnostic seat picture as following : our CAT Caterpillar ET Diagnostic Tool 9 pin connecter picture as following : pls check ( the left is the vehicle diagnostic seat .and the right is cat device 9 pin connecter . Vehicle connection is: A – Battery Negative
阅读全文

Injection Disabled on Status Flags Caterpillar ET Software

  Injection Disabled →If a SHUTDOWN is active,  Injection Disabled  will appear on Status Flags Caterpillar ET . →An Engine shutdown event will appear on a CAN J1939 device if the device is capable of displaying Diagnostic Codes.→No active error on Engine's display (such as: Murphy PowerView, etc), but Engine can't STARTS (Cranking only).  #Possible Causes: 1). Engine Overspeed Shutdown The Operator may be operating the Engine incorrectly. The "Engine Overspeed" parameter may be incorrectly programmed for the application, use Caterpillar ET to view the parameter setting for Engine Overspeed. 2). 75% Overspeed Verify Switch (OS Verify) Faulty on wiring, switches, or connectors. Check the 75% Overspeed Verify Switch (If installed), it will sending "Ground Signal" to the ECM while activated (Overspeed Test Switch). ECM pin 54 (C-15 Engine).   3). Low Engine Coolant Level Shutdown The Engine has been running for one minute and the Coolant Level is
阅读全文