Caterpillar Solution

WABCO System Diagnostics Kit WABCO Diagnosis Tool for Bus Truck WABCO DIAGNOSTIC KIT WDI WABCO System Diagnostics tool Wabco Diagnostic Kit is a universal diagnostic tool designed for maintenance of trailers, trucks and buses. Wabco Diagnostic tool supports most popular and wanted diagnostic protocols for wider compatibility range. Wabco Diagnostic Kit comes with a full set of diagnostic software which allows you to connect to almost all necessary electronic, hydraulic and pneumatic systems or modules WABCO DIAGNOSTIC KIT is A wide range of diagnostic hardware, and supply completes the System Diagnostics package. easy-to-use blink code plug, digital testers, conformity test unit, adapters and cables, and a complete test bench. This article is about wabco diagnostic software step by step installation instructions. 1. Run the installation package   2. Folling the prompts to choose   3. Waiting for installation to complete   4. Run the activation patch    5. Open the softwar

  Injection Disabled →If a SHUTDOWN is active,  Injection Disabled  will appear on Status Flags Caterpillar ET . →An Engine shutdown event will appear on a CAN J1939 device if the device is capable of displaying Diagnostic Codes.→No active error on Engine's display (such as: Murphy PowerView, etc), but Engine can't STARTS (Cranking only).  #Possible Causes: 1). Engine Overspeed Shutdown The Operator may be operating the Engine incorrectly. The "Engine Overspeed" parameter may be incorrectly programmed for the application, use Caterpillar ET to view the parameter setting for Engine Overspeed. 2). 75% Overspeed Verify Switch (OS Verify) Faulty on wiring, switches, or connectors. Check the 75% Overspeed Verify Switch (If installed), it will sending "Ground Signal" to the ECM while activated (Overspeed Test Switch). ECM pin 54 (C-15 Engine).   3). Low Engine Coolant Level Shutdown The Engine has been running for one minute and the Coolant Level is